Accessibility Widget: On | Off

SRAM PressFit 30 Bottom Bracket

Views:
Average User Rating: (Terrible)
Create New Tag

Need more info? View our MTB Bottom Brackets buyer's guides.

1 member review

junk, don't even consider

Rating:
The Good:

it spins for a while

The Bad:

cheap bearings, even cheaper plastic

Overall Review:

This is a PF 30 BB that should not exist, its utter rubbish. The bearings are not held by the plastic well at all. You would never use this BB on a bike your going to ride, selling a bike and need a BB would be the only scenario anyone would use one of these.

This is one of the most common BB's to ship in bikes. If it lasts 1000 km you are lucky. The bearings are not held by the plastic well at all, during assembly you will find that the bearings are almost an interference fit to the axle, but the bearings can be pushed in and out of the cups by hand. Instead of assembling with both bearings pressed into the cups first, press cups in, then put bearing onto drive side of the spindle, and push into cup. Then place bearing onto non drive side, and gently tap home as best you can, then use the nds adjuster to pull together.

Use RTV gasket maker, Permatex, on cups to frame interface to eliminate creaking/cup migration. Ships with terrible grease on the bearings too. I'd wash it out with Naptha and regrease too.

Rate review:

0 comments newest first

Show More Comment(s)
Specifications
Product SRAM PressFit 30 Bottom Bracket
Shell Type Press Fit
Shell Width 68-92mm
Bearing Type Ceramic or standard
Spindle Width
Spindle Material
Spindle Interface 30mm
Weight N/A
Miscellaneous
Price
  • $50
  • $245
More Info

sram.com

What do you think?
Photo Manager | Double-click to insert a photo | Insert Photo Group

Choose Layout

2-stack Images
3-stack Images
4-stack Images
Add Photos
Your rating:
  • Five stars
  • Four and a half stars
  • Four stars
  • Three and a half stars
  • Three stars
  • Two and a half stars
  • Two stars
  • One and a half stars
  • One star

More Products